The prep for installation costs very little since all you really need is a blade and sandpaper. These lights come in a range of prices depending on the style you choose. If you already have the tools on hand, there should be not out of pocket expenses outside of the ceiling lights. If you use a saw, you definitely need to sand the outside.To save time, you can use an electric saw to expose the hole for the light.Smooth down the edge with sandpaper, if necessary.Once you are done scoring the surface, firmly snap along the line.With firm ceilings, take a page out of the pros’ book and make a score along the line (about every half inch).If your ceiling is soft, simply use and cut out the dimensions of the hole.A common ceiling type is acrylic.įor this, professionals score the surface and break it along the perforation. It all depends on your ceiling materials. There are lots of different ways to cut ceiling panels. Nowadays there are other anti-mold paints available as well that work well for darker colors such as black or brown if white or other lighter colors are not desired.ĭon’t miss our article on how to splice low-voltage landscape lighting wire. The edges should then be sanded down with an orbital sander using 100-grit sandpaper, followed by 150-grit sandpaper, and finally 220-grit sandpaper before painting them white for a finished look. To snap off the hard plastic panel edge along the scored line, pull down on the plastic panel edge in one smooth move. Run the acrylic scoring instrument four to five times down that cutting line using the guide provided by the metal straightedge.įirmly grasp the plastic panel edge with one hand while holding the main section of the panel steady with the other. Place the metal straightedge along the cutting line. Place the panel of hard plastic on a flat surface. It’s important that you use heavy work gloves! The edges of hard plastic panels may be cut with a sharp knife. Allow for 1/8 inch to fit within the railing of the ceiling tile grid for an expert appearance. 1/8 inch should be added on each side and then recorded onto the hard plastic ceiling panel with a metal straightedge and a pencil for a professional look. To choose the spot where the hard panel will be placed, measure the ceiling. First, one should use a pair of tin snips or aviation shears on the corners of the panel that needs to be cut off.
0 Comments
Leave a Reply. |